Dear customers!

Currently, product delivery is only available via OMNIVA.
We apologize for any inconvenience caused.

MX1508 2-channel DC motor driving

MX1508 2-channel DC motor driving

No reward points for this product.

2-channel DC motor driving module

More details...

Availability : This product is no longer in stock


3,40 €

Notify me when available

2-channel DC motor driving module Positive inversion PWM speed mini motor dual h-bridge stepper motor driver

Products introduction: motor drive module very for in battery power of intelligent car, and toy car, and robot, above using, power voltage 2V~10V, can while drive two a DC motor or one 4 line 2 phase type step into motor, can achieved pros and cons turned and adjustable speed of function, each road current can to 1.5A continued current, peak current can up 2.5A, has hot protection and can automatically recovery.

Product highlights:

  • The imported professional motor drive chip, low built-in guide through the internal resistance of the MOS switch tube, heating minimal, no need for heat sinks, small volume, electricity saving, and is an ideal choice for your battery powered.
  • (L298N internal switching transistors, low efficiency, high fever, heat, heavy volume, market L298N is easy to burn out, without the use of the original chips, this product can.
  • Dual 1.5A*2, peak current can be to 2.5A, built in overheating protection circuit, do not afraid of blocking the motor burned out, the temperature drops automatic recovery. (current smart car voltage and current in the market are in this range)
  • small size, light weight, 0 standby current, is the ideal choice for your model car.
Product parameters:
  • double way H bridge motor drive, can drive both DC motor or 4 1 wire two phase stepper motor;
  • module power supply voltage 2V-10V;
  • signal terminal
  • input voltage 1.8-7V;
  • single channel current of 1.5A, peak current up to 2.5A, low standby current (less than 0.1uA);
  • built-in common conduction circuit, the input end is suspended, the motor will not malfunction;
  • Overheat protection circuit with 7 built-in hysteresis effect (TSD), there is no need to worry about motor stall;
  • Product size: 8 24.7*21*5mm (LxWxH), ultra small size, suitable for assembly and vehicle;
  • mounting hole diameter: 2 mm.
  • weight: 5g
Matters needing attention:
  • the positive electrode and the negative electrode will cause the circuit damage.
  • The output to ground short circuit and the output end of the short circuit, and motor block of chip will thermal protection, but in close to or more than 10V voltage and peak current greatly exceed 2.5A will cause chip burned.

Write your review

MX1508 2-channel DC motor driving

MX1508 2-channel DC motor driving

2-channel DC motor driving module

Write your review

29 other products in the same category :

Motor Drive Shield L293D for Arduino

Motor Drive...

5,00 €

Servos Bracket 2 DOF Long Pan and Tilt


12,00 €

Servo bracket PT Pan/Tilt Camera Platform for SG90 MG90


2,40 €

L298N motor driver

L298N motor...

3,40 €

L9110S H-bridge Dual DC Stepper Motor Driver


2,90 €

DRV8825 Stepper Driver


2,90 €

Servo Mount Holder Bracket For SG90 MG90

Servo Mount...

1,20 €

DRV8830 I2C DC Motor Driver Control

DRV8830 I2C...

8,60 €

Plastic Tire Wheel

Plastic Tire...

3,20 €

TT Gear Motor speed encoder

TT Gear...

0,90 €

TT Gear Motor Bracket

TT Gear...

1,90 €

TT Gear Motor Bracket (Acryl)

TT Gear...

1,90 €

25T Servo Arm Horn Aluminum

25T Servo...

1,80 €

VNH2SP30 Stepper Motor Driver 30A


8,20 €

TT Gear Motor Bracket Iron

TT Gear...

2,10 €

VNH2SP30 Stepper Motor Driver 30A Monster


11,60 €

L298N DC Stepper Motor Driver Shield

L298N DC...

9,90 €

NEMA 17 Mounting L Bracket

NEMA 17...

4,80 €

Stepper Motor Shaft Couplings Flexible 5*8*25 mm


1,90 €

16 Channel 12-bit PWM/Servo Driver (I2C, PCA9685)

16 Channel...

4,60 €

A3967 V4.4 EasyDriver

A3967 V4.4...

4,20 €

L298 Motor Shield (4A Dual Channel Motor Driver)

L298 Motor...

14,90 €

Motor Speed Varible Regulator

Motor Speed...

3,20 €

Motor Shield V2.0

Motor Shield...

9,90 €

L293D 4-Channel Motor Drive Shield


3,20 €

L298P Motor Drive Shield

L298P Motor...

8,50 €

PCA9685 16 Ch/12-bit PWM/Servo Shield Driver I2C Interface

PCA9685 16...

5,80 €

A4988 Stepper Driver


2,40 €

Stepper Motor Shaft Couplings Flexible 5*5*25 mm


1,90 €


No products

0,00 € Shipping
0,00 € Total

Check out


Darba laiks: 10.00-13.00 (on working days)

tālr.+371 27474705


Adress: Rīga, Limbažu iela 1/1