E18-D80NK new head with DuPont
Proximity sensor - NPN, 17 mm, 3 wire, 3-80CM
This is a set of transmitter and receiver in one of the photoelectric sensors. 1 detection distance can be adjusted according to the requirements . The sensor has a detection distance , by small visible light interference , cheap, easy to assemble , easy to use features , can be widely used in robot obstacle avoidance, line piecework and many other occasions.
Electrical Characteristics :
- U: 5VDC
- I: 100mA
- Sn: 3-80CM
- Size :
- Diameter : 17MM
- Sensor length : 75MM
- Lead Length : 45CM
Photoelectric sensors ( photoelectric switch ) NPN normally open
Photoelectric switch E18 technical parameters :
- The output current DC / SCR / Relay Control output: 100mA / 5V power supply
- Current consumption DC u003c25mA
- Response time u003c2ms
- Point angle : ≤15 °, effective distance 3-80CM adjustable
- The detection object : opaque
- The working environment temperature : -25 ° ~ + 55 °
- The standard sensing object : sunlight 10000LX less incandescent 3000LX the following
- Case Material : Plastic
Sensors answer frequently asked questions about :
1 , Q: This is a digital sensor or analog sensors
A: This NPN type photoelectric switch. Output Group Aung station is 0,1 , namely a digital circuit high and low
2, Q: What is the level of output is detected the target object ?
A: The goal is to detect low-level output , the normal state is high output
3 , Q: Can the microcontroller IO port received ?
A: The output of an external pull-up resistor can be connected to the IO port
4 , Q: How much pull-up resistor ?
A: pull-up resistor is generally about 1K
5, Q : Where can I download the manual ? Or manual too simple
A: This is a photoelectric switch, three lines , power, ground and output , not too complicated introduce digital output , does not require AD conversion can be directly connected to the microcontroller IO port on the rear of the adjustable potentiometer to adjust the distance ( 3 -80CM valid )