E18-D80NK new head with DuPont
E18-D80NK new head with DuPont
E18-D80NK new head with DuPont
E18-D80NK new head with DuPont
E18-D80NK new head with DuPont
E18-D80NK new head with DuPont

E18-D80NK new head with DuPont

Tuvuma sensors - NPN, 17 mm, 3 wire, 3-80CM

00944
Nav noliktavā
5,90 €


 

This is a set of transmitter and receiver in one of the photoelectric sensors. 1 detection distance can be adjusted according to the requirements . The sensor has a detection distance , by small visible light interference , cheap, easy to assemble , easy to use features , can be widely used in robot obstacle avoidance, line piecework and many other occasions.


Electrical Characteristics :

  • U: 5VDC
  • I: 100mA
  • Sn: 3-80CM
  • Size :
    • Diameter : 17MM
    • Sensor length : 75MM
    • Lead Length : 45CM


Photoelectric sensors ( photoelectric switch ) NPN normally open

Photoelectric switch E18 technical parameters :

  • The output current DC / SCR / Relay Control output: 100mA / 5V power supply
  • Current consumption DC u003c25mA
  • Response time u003c2ms
  • Point angle : ≤15 °, effective distance 3-80CM adjustable
  • The detection object : opaque
  • The working environment temperature : -25 ° ~ + 55 °
  • The standard sensing object : sunlight 10000LX less incandescent 3000LX the following
  • Case Material : Plastic


Sensors answer frequently asked questions about :
1 , Q: This is a digital sensor or analog sensors
A: This NPN type photoelectric switch. Output Group Aung station is 0,1 , namely a digital circuit high and low

2, Q: What is the level of output is detected the target object ?
A: The goal is to detect low-level output , the normal state is high output

3 , Q: Can the microcontroller IO port received ?
A: The output of an external pull-up resistor can be connected to the IO port

4 , Q: How much pull-up resistor ?
A: pull-up resistor is generally about 1K

5, Q : Where can I download the manual ? Or manual too simple
A: This is a photoelectric switch, three lines , power, ground and output , not too complicated introduce digital output , does not require AD conversion can be directly connected to the microcontroller IO port on the rear of the adjustable potentiometer to adjust the distance ( 3 -80CM valid )

Nav atsauksmju

16 citi produkti tajā pašā kategorijā:

Produkts ir pievienots vēlmju sarakstam
Produkts pievienots salīdzināšanai.

Mūsu interneta vietnē tiek izmantoti sīkfaili. Sīkfaili palīdz nodrošināt pienācīgu vietnes darbību un tās pilnveidošanu, tāpēc obligātie sīkfaili (tehniskie, funkcionālie un analītiskie) tiek instalēti automātiski. Lai individualizētu jūsu sērfošanas pieredzi un sniegtu piedāvājumus, kuri būtu aktuāli tieši jums, tīmekļa vietnē tiek izmantoti arī mērķa sīkfaili. Nospiežot “piekrītu”, jūs piekrītat mērķa sīkfailu instalēšanai un izmantošanai. Savu piekrišanu varēsiet atsaukt jebkurā laikā, nomainot sava interneta pārlūka iestatījumus un izdzēšot ierakstītos sīkfailus. Vairāk informācijas – sīkfailu politikā