LilyPad

Microcontroller: ATmega328P
Operating voltage: 2.7V ~ 5.5V (recommended 5V)
Input voltage: 2.7V ~ 5.5V (recommended 5V)
Digital I/O pins: 14 (of which 6 provide PWM output)
Analog input pins: 6
DC current per I/O pin: 40mA
Flash memory: 16KB (of which 2KB used by bootloader)
SRAM: 1KB
EEPROM: 512bytes
Clock speed: 16MHz

Note:

Don't power the LilyPad Arduino with more than 5.5V, or plug the power in backwards: you'll kill it.

GENERAL INFORMATION

Arduino LilyPad platform is designed to be used as part of clothing. It can be sewn into the fabric with built-in power supply, sensor and actuator wiring. The platform is built on a microcontroller ATmega168V (low-power version with ATmega168) (technical data) or ATmega328V (technical data). Arduino LilyPad was created by Leah Buechley and SparkFun Electronics.

Programming

Platform programmed with Arduino software version 0010 or higher. However, it is possible to record a program earlier software version Arduino, but some functions are not available.

Microcontrollers and ATmega168V ATmega328V come with recorded loader facilitating entry of new programs via software Arduino .. You can not use the bootloader and program the ATmega conclusions through ICSP (in-circuit programming). Detailed information can be found in this manual. 

Food

Arduino LilyPad can be powered via the USB connection or an external power supply.

External supply voltage should be between 2.7 and 5.5 V. The voltage can be supplied via the inverter AC / DC (power supply unit) or battery. Never connect a voltage greater than 5.5 V, or change its poles, it can damage the platform.

Physical characteristics

LilyPad platform is a circle with a diameter of 50 mm. Thickness is 0.8 mm platform, and in the place of installation of the microcontroller and conclusions - 3 mm.

Washability

It is possible to erase the. We recommend using mild detergent. Should not be pressing. Before washing, you must disconnect.